Installation guide

Hawse Fairlead Part Number 10102

How to install the Grimm OffRoad Hawse Fairlead part number 10102.

Shop this part
Hawse Fairlead Part Number 10102
Number of Steps5
DifficultyEasy
Time Required15 - 30 minutes

Tools

  • 15mm Wrench1
  • 6mm Allen Key1

Parts

  • Grimm Offroad Hawse Fairlead1
  • M10x1.5x50mm Button Head Screw2
  • M10 Washer2
  • M10x1.5 Flange Nut2
STEP 1

Included Parts

!
Verify that all parts shown in the picture are present.
STEP 2

Remove Existing Fairlead (If Equiped)

Remove the existing fairlead if there is one to be replaced.
STEP 3

Route Winch Line Through Fairlead

Remove any existing hooks from winch line so that the line may be passed through the fairlead.
Install one washer and button head screw through the fairlead, and then pass the winch line through the fairlead.
Insert the screw through the fairlead mounting hole and let the fairlead hang.
Install a flanged nut on the backside of the screw and thread it on a few turns.
STEP 4

Tighten Fairlead Hardware

Insert hardware through the other side of the fairlead and install nut on backside.
Snug hardware on each side. With hardware snug, position the fairlead so that the winch line cannot contact the fairlead mount or bumper mount edges.
i
With the fairlead correctly positioned, torque hardware to 25 lb-ft [34 Nm].
STEP 5

Torque Hardware

Install hook on winch line and re-spool the winch line.
!
Recheck hardware and winch line periodically to prevent failure.

Conclusion

Installation is complete!

With any modified vehicle, or any vehicle used offroad, it is a good idea to check bolt torques periodically and visually inspect components regularly.

Grimm Offroad installation instructions