Installation guide

Jeep JK A Pillar Light Mounts Part Number 10247

How to install the Grimm OffRoad Jeep JK A Pillar Light Mounts part number 10247.

Shop this part
Jeep JK A Pillar Light Mounts Part Number 10247
Number of Steps4
DifficultyEasy
Time Required1 - 2 hours

Tools

  • T40 Torx Driver1
  • Various Other Tools Depending On Lights Mounted1

Parts

  • Jeep JK A Pillar Light Mount - Left1
  • Jeep JK A Pillar Light Mount - Right1
STEP 1

Included Parts

!
Verify that all parts shown in the picture are present.
STEP 2

Remove Windshield Frame Bolts

The mounts use the two factory torx bolts at the base of the windshield frame.
Using a T40 torx driver, remove the two bolts.
STEP 3

Install Light Mounts

Identify the left and right side brackets. The mounts can only fit one way, see images.
Place the light mounts over the windshield frame holes and re-install hardware.
i
Torque hardware to 15 lb-ft [20Nm]
STEP 4

Install Lights

Install lights onto light mounts.
Follow wiring instructions provided by the light manufacturer.

Conclusion

Installation is complete!

With any modified vehicle, or any vehicle used offroad, it is a good idea to check bolt torques periodically and visually inspect components regularly.

Grimm Offroad installation instructions